John Deere DH56 Series Offset Disks
Adjustable disk blade scrapers increase productivity
Adjustable disk blade scrapers keep disk blades clean and performing in wet and sticky soils for increased productivity.
End washers and wrenches keep gang shaft end nut tight
End washers help keep the gang shaft end nut tightened during operation, increasing gang wear life.
Two gang nut wrenches are supplied with each unit and securely attached to the unit, ready to use when the gangs need tightening.
Transport locks secure disk wings
Transport locks are standard, ensuring disk wings are in secure transport mode.
Two separate control arms create consistent performance
Two separate control arms are standard, one for transport leveling and one for leveling while the disk is in the ground. Once set for a given soil condition, the disk will continue to perform with consistency.
Oil bath tapered roller bearings minimize maintenance
Oil bath tapered roller bearings, sealed with industrial-grade seals, keep maintenance to a minimum and profitable working hours at a maximum. The bearings come complete with a wear plate.
|Ground clearance with base blades|
|Wheel hub bearings||Dual tapered roller bearings|
|Approximate working width||3 m
|Weight per disk blade||393.7 kg
|Recommended PTO hp range|
|Recommended drawbar hp range||167.8 kW
|Type||Single offset rigid|
|Tube size||20.3x20.3x1.3 cm
|Front hitch type||Pintle|
|Bolt-on rear hitch|
|Type||Notched (front) Notched (rear)
Available blade sizes
|Blade option one||914x12.7 mm
|Blade option two|
|Blade option three|
|Blade option four|
|Blade option five|
|Blade option six|
|Front angle||3 positions|
|Rear angle||3 positions|
|Axle size||6.4 cm
|Axle material||Round heat treated alloy steel threaded on both ends|
|Bearing type||Oil bath tapered roller|
|Bearing wear plates||Standard|
|Bearing standards||Welded, reinforced|
Lighting and safety
|Safety tow chain||Yes|
|Type||2 - Radial Industrial|
|Wheel hub type||5-spoke Dayton hubs|
|Labor hours||For two people: 2-3 hours|
|Time period||1 year|
|Approximate working width|
|Notched (front) Notched (rear)|
|Recommended drawbar hp range|
|Transport - Width|