H&S X-15

New Equipment / H&S / Rakes / X-15 Rake / X-15

The H&S X-15 Rakes feature a highly maneuverable short turning radius, no caster wheel design, and an overhead frame design for high volume capacity of the crop.
The variable main frame width adjustment opens symmetrically. Hitch height and beam fore and aft tilt are controlled by a simple ratchet jack.
Hydraulic adjust beam angle as standard equipment.
Tandem ST175/80D13 tires w/rims are standard equipment.
The X-15 Rake has a proven ground pressure system and rake arm design.
The X-15 Rake has 100% coverage, there is no need for center kicker wheels. The 3 wheel extension can be locked up if not needed.
One side raking can be done with the right or left side.
The hydraulic beam angle kit adjusts right and left beam angles.
An electric-over-hydraulic toggle switch adjusts the left and right beam angle – the neutral position of the toggle switch adjusts main frame width.
Optional rake wheel wind boards help to keep the crop from wrapping on the rake wheels.
Work lights are optional.

X-15
WHEEL DIAMETER	55"
TEETH PER WHEEL	40
TOOTH DIAMETER	7mm (.275")
RAKE WHEEL HUBS	Tapered Roller Bearings
TRANSPORT WIDTH	10' 4"
TRANSPORT LENGTH	31' 6"
WINDROW WIDTH ADJUSTMENT	Up to 46"
RAKING WIDTH	Up to 25'
HITCH JACK	Standard
STANDARD TRANSPORT WHEELS	(4-Tandem) ST175/80D13
WEIGHT	3023#
RAKE WHEEL WIND GUARDS	Optional
TRANSPORT LIGHTS	Optional
HORSEPOWER REQUIREMENTS	40 (30kW)
HYDRAULIC REQUIREMENTS	1 Double acting remote for main frame open and close. 1 Single acting remote for rake wheel lift.
ELECTRICAL REQUIREMENTS	+ 12 volt power source for hydraulic beam angle kit.

X-15